IDEC SmartRelay FL1D Series - Setting the Default Values for IDEC Smartrelay; Setting the Time-Of-Day and Date (FL1 D-H12 RC

Configuring IDEC SmartRelay
237
IDEC SmartRelay Manual
5.2 Setting the default values for IDEC
SmartRelay
You can set the following default values for IDEC
SmartRelay:
Clock settings
You can set the default values for time-of-day and date,
summertime/wintertime conversion and synchronization
• in parameter assignment mode by means of the set menu
(“Clock” menu item)
• in programming mode by means of the setup menu
(“Clock” menu item).
Time-of-day and date see Chapter 5.2.1.
Summertime/wintertime conversion see Chapter 3.6.13.
Synchronization see Chapter 3.6.14.
Contrast settings
You can set the default value for the display contrast
• in parameter assignment mode by means of the set menu
(“Contrast” menu item)
• in programming mode by means of the setup menu
(“Contrast” menu item).
See Chapter 5.2.2.
Start screen settings
You can select the default setting for the start screen
• in parameter assignment mode by means of the set menu
(“StartScreen” menu item).
See Chapter 5.2.3.
5.2.1 Setting the time-of-day and date
(FL1D-H12RC...)
You can set the TOD and the date
• in parameter assignment mode by means of the set menu
(“Clock” menu item).
• in programming mode by means of the setup menu
(“Clock” menu item).
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com