IDEC SmartRelay FL1D Series - Default Chapter; Table of Contents

IDEC SmartRelay Manual v
Contents
Preface.............................................................. i
1 Getting started with IDEC SmartRelay ......... 1
2 IDEC SmartRelay installation and wiring ... 13
2.1 Modular IDEC SmartRelay setup ........................................ 17
2.1.1 Maximum setup .................................................................. 17
2.1.2 Setup with different voltage classes.................................... 18
2.2 Installing/removing IDEC SmartRelay ............................... 19
2.2.1 DIN rail mounting ................................................................ 20
2.2.2 Wall-mounting..................................................................... 24
2.3 Wiring IDEC SmartRelay ..................................................... 26
2.3.1 Connecting the power supply ............................................. 27
2.3.2 Connecting IDEC SmartRelay inputs.................................. 29
2.3.3 Connecting outputs............................................................. 40
2.3.4 Connecting the AS interface bus ........................................ 44
2.4 Putting into operation ......................................................... 46
2.4.1 Switching on the IDEC SmartRelay/Power On ................... 46
2.4.2 Operating states ................................................................. 50
3 Programming IDEC SmartRelay.................. 52
3.1 Connectors........................................................................... 54
3.2 Blocks and block numbers ................................................. 57
3.3 The way to IDEC SmartRelay, starting with the circuit
diagram................................................................................. 60
3.4 The four golden rules for operating IDEC SmartRelay .... 63
3.5 Overview of IDEC SmartRelay menus ............................... 65
3.6 Writing and starting the circuit program ........................... 66
3.6.1 Select programming mode.................................................. 66
3.6.2 The first circuit program ...................................................... 68
3.6.3 Circuit program input .......................................................... 69
3.6.4 Assigning a circuit program name ...................................... 75
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com