Programming IDEC SmartRelay
IDEC SmartRelay Manual 94
values of the analog outputs change as well, depending on
the setting.
5. Select the desired output setting: Press ▲ or ▼.
6. To confirm your entry: Press OK
Defining a specific analog output value
You want to output a specific analog value at the two analog
outputs.
1. Move the ‘>’ cursor to ‘Defined’: Press ▲ or ▼
2. Confirm ‘Defined’: Press OK
The display shows:
AQ1: 00.00
AQ2: 00.00
3. Enter a specific output value for each of the two analog
outputs.
4. To confirm your entry: Press OK
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...