IDEC SmartRelay memory cartridge (card)
245
IDEC SmartRelay Manual
Enabling copy protection
To enable copy protection:
1. Move the ‘>’ cursor to ‘Yes’: Press ▲ or ▼
2. Confirm ‘Yes’: Press OK
IDEC SmartRelay shows the following display:
>No
Yes
CopyProtect:
Yes
Note
This only generates a circuit program and copy protection for the
memory cartridge (card); the circuit program itself must be copied
separately from the IDEC SmartRelay to the memory cartridge
(card) (can also be done initially).
You can always change the “No” status (security function disabled)
to “Yes” (security function enabled).
A status change from “Yes” (security function enabled) to “No” (se-
curity function disabled) is only possible if the memory cartridge
(card) does not contain a circuit program.
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...