idp SMART-81 - Page 53

53
> Black Text: to extract resin black for text only.
> Black Dots: to extract resin black for all of black.
> Black Dots Only: to extract resin black for all of black and not to print on color
panels.
> Not Use: not to extract resin black.
 Extra Control: other options.
- Resin Thick Mode: Compensate for blurry text
 Wait Option: Turning on this option allows the card to wait for a specified amount of
time in each location when encoding to a smart card without using the SDK.
If not using the SDK, only wait for the specified amount of time, so you must write a
program the recognizes and encodes smart card within the specified amount of time.
- Wait at Contactless Encoding Position [On/Off]: to set whether to wait at the
internal RF encoder or not.
> Card Side [Front/Back]: to set the direction to card when waiting.
> Wait Position [-100:100]: to set the position of card to wait from the criteria
position. Unit is 0.1mm.
> Wait Time [0:1000]: to set time to wait. Unit is second.
- > Wait at Contact Encoding Position [On/Off] : to set whether to wait at the
internal IC encoder or not.
> Card Side [Front/Back]: to set the direction to card when waiting.
> Wait Position [-100:100]: to set the position of card to wait from the criteria
position. Unit is 0.1mm.
> Wait Time [0:1000]: to set time to wait. Unit is second.