59
③ Click “Card printer” tab.
If laminator or flipper is installed, you can setup laminator or flipper setting value
by “Laminator” tab or “Flipper” tab.
④ To show Printer information.
Firmware version, serial number of printer and serial number, resister & type of
print head.
⑤ To show print area
It shows exaggeratingly for user convenience.
⑥ To set print area.
Please set it properly to print on an entire card because SMART – 81 is retransfer
type card printer. When you check “⑧ Print”, a card is printed as like “⑤
example”. Please set values properly that all circles of each corner are printed
and black spaces are 0.4mm ~ 0.5mm in the top and the bottom of a card. Please
set values by following order.
X: Print Position: Please set right and left properly by adjusting X position.
Y: Print Position: Please set the start position of printed with adjust value.
Y: Print Scale: Please set to show circles in the bottom
Y: RT Position: Please set the top and bottom position with adjust value
Y: Front RT Length: Ensure the end of image is printed and film does not leave
a mark on film when retransferring with adjust value. (adjustment value
when printing one side)
Y: Back RT Length: Ensure the end of image is printed and film does not leave
a mark on film when retransferring with adjust value. (adjustment value of
back side when printing both side)
⑦ To set density.
SMART-81 enables to set different density for each color, resin black and
overlay. Please set each density for high quality and optimize the quality by
adjusting each value. Insert the color ribbon(YMCK) and click “⑧ Print” to print
the card to optimize each setting.
Total Density: To set all the density (Color, Black, Resin) at one time.
To Next Page
Loading...
