idp SMART-81 - Page 75

75
③ Print: Print test with CSD file which is designed by Smart ID program.
④ Batch Start: Repeat selected encoding test by “⑤ Encoding”.
⑤ Encoding: Encode Magnetic Stripe, Contact Card, Contactless Card.
⑥ Printer Status: Check printer status.
⑦ Message: Description of status by log.
(2) Select Printer and Control
Control is consisted by SBS (Step by Step), Move, Rotate, Etc. section and you can control
printer by each step.
 SBS
SBS is to operate SMART printer in SBS(Step-By-Step) mode which you can control the
printer using commands. In SBS mode, after printing data transmission, printing a card
will be run only by clicking “DoPrint”. It is the main difference between NORMAL mode
and SBS mode. When you click “Start”, SMART-81 is operated in SBS mode, and
existing spooled data will be eliminated. To exit SBS mode, click “End”.
.
 Card
Card is to bring a card into printer and eject a card. “In” is to move a card from input
hopper to printer and “Out” is to move a card from printer to output hopper. In case
the flipper is installed, “Back” ejects a card to the back side.
 Move
Move is to move a card to specific position in the inside of printer. “Print” is to move a
card to the printing position, and “Mag.” is to the magnetic encoding position, and “IC”
is to the contact smartcard encoding position, and “RF” is to the contactless
smartcard encoding position. “To Rotator” is to move a card from printer to flipper and
“From Rotator” is to move a card from flipper to printer. “from In” is to move a card
from the card in sensor to where you define position, and “from Out” is to move a card
from the card out sensor to where you define position.