Immergas VICTRIX EXTRA 12 PLUS - Page 108

108
INSTALLER
USERMAINTENANCE TECHNICIAN
TECHNICAL DATA
(A)
(B)
(C)
79
Key (Fig. 79):
(A) - Top set
(B) - Lower set
(C) - Days
TM - Flow temperature
e function lasts in total 7 days, 3 days at the lower temperature set and 4 days at the higher temperature set (Fig. 79).
When the function is active, the current ow temperature is displayed (read by the ow probe) alternating with the countdown of the days
remaining until the end (7, 6, 5, etc.). In addition, the symbol (indicating the disposal of heat to the heating system) and the symbol
(indicating the possible forced termination of the function by pressing the RESET button) are displayed in ashing mode.
In case of failure or lack of supply voltage, the function is suspended and will resume when the normal operating conditions are reset
from the point where it was interrupted.
When the time expires, the boiler automatically goes back to "Stand-by" mode, the function can also be stopped by pressing the "RESET".