11 - 1
Transpector MPH Operating Manual
Chapter 11
Specifications
11.1 Introduction
The following sections detail the specifications for the Transpector MPH Gas
Analysis System. As a result of INFICON continuing product improvement and
quality assurance programs, these specifications are subject to change without
notice or obligation.
NOTE: All specifications are measured after a 30 minute warm-up period at
constant STP unless specified.
11.2 Sensor Length (Vacuum Side)
11.3 Mass Range
11.4 Detector Type
MPH100F MPH100M MPH200F MPH200M MPH300F MPH300M
143 mm 193 mm 143 mm 193 mm 143 mm 193 mm
(5.63 in.) (7.82 in.) (5.63 in.) (7.82 in.) (5.63 in.) (7.82 in.)
MPH100F MPH100M MPH200F MPH200M MPH300F MPH300M
1 to 100 AMU 1 to 200 AMU 1 to 300 AMU
MPH100F MPH100M MPH200F MPH200M MPH300F MPH300M
Faraday Cup Continuous
Dynode
Electron
Multiplier /
Faraday Cup
Faraday Cup Continuous
Dynode
Electron
Multiplier /
Faraday Cup
Faraday Cup Continuous
Dynode
Electron
Multiplier /
Faraday Cup
To Next Page
Loading...
