5 - 3
Transpector MPH Operating Manual
5.3 Connecting to Transpector Web UI
To connect to Transpector Web UI, the device that is being used for operating
Transpector Web UI must be connected to the same network as Transpector MPH.
If the device is not connected to the same network as Transpector MPH,
Transpector Web UI will not work. In this situation, connecting to a computer that
is on the same network via remote desktop is necessary. Transpector Web UI will
then run on the remote desktop computer.
5.3.1 Connecting to Transpector Web UI with Default Factory IP address
The default web address for Transpector MPH is 192.168.1.100. To connect to
Transpector Web UI, type 192.168.1.100 into the browser address box, then
press Enter. See Figure 5-1.
Figure 5-1 Navigating to Transpector Web UI
NOTE: The device running the browser must also be configured with an address
on this network (e.g., 192.168.1.101).
The browser will connect to Transpector MPH. If Transpector MPH is powered on
and connected to the same network as the device, the TranspectorWebUI
STATUS webpage will display. See Figure 5-2.
To Next Page
Loading...
Need help?
General
