Thermography System VarioCAM
®
HD
10. Introduction
User Manual © InfraTec GmbH 2016 83
10 Software installation
10.1 Installation instructions
In order to operate the VarioCAM
®
HD using the GigE interface, the driver software “WinPcap” must be
installed first. We recommend using a GigE network card - independent of the company’s network - in
order to actuate the VarioCAM
®
HD. Depending on the used Ethernet adapter, different configuration
options will be available after the Ethernet adapter is installed.
We recommend using the internal GigE network card at all times for camera connection.
For the installation described below, you must dispose of the access rights of the user group,
"
Administrators
"
.
10.2 Installation of WinPcap
Upon execution of the file "WinPcap_4_1_2.exe", please follow the setup wizard by always clicking
"Next >".
Fig. 198 Start window
To Next Page
Loading...