Ingenico 5100 - Ingenico 5100 Port Layout

SKYZER TECHNOLOGIES PAGE 18 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
2.2.5 Port Layout
The following ports are as defined at the rear of the Ingenico 5100 terminal.
Figure 6 – Port Layout for Ingenico 5100
Note: The SkyPay-300 reader can be connected to either ports, RS232-1 or
RS232-2 as long as it’s been activated for that port. Refer to page 37 for
instructions on activating the SkyPay-300 reader port to operate on.
If the SkyPay-300 reader is activated on RS232-2 port, then the ECR interface
cannot be enabled due to RS232-2 port in use by SkyPay-300 reader.
Power Port
PSTN/Telephone
Port
Pinpad/SkyPay-300
Port
ECR Interface/SkyPay-300
Port
Ethernet
Port