Ingenico 5100 - Contactless Configuration

SKYZER TECHNOLOGIES PAGE 37 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
3.5.1 Contactless Configuration
This function allows the merchant to select the preferred COM port to operate
contactless solution through.
Perform the following steps to select the COM port to have the contactless
solution on.
Step
Terminal Display
Description
1.0
Press FUNC
2.0
FUNCTION?
FUNCTION?FUNCTION?
FUNCTION? Enter 7418, press ENTER
3.0
MULTI MERCHANT
MULTI MERCHANTMULTI MERCHANT
MULTI MERCHANT
SETUP
SETUPSETUP
SETUP
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
4.0
CONTACTLESS
CONTACTLESSCONTACTLESS
CONTACTLESS
COM PORT
COM PORTCOM PORT
COM PORT
0
00
0-
--
-NONE
NONENONE
NONE
1
11
1-
--
-COM1
COM1COM1
COM1
2
22
2-
--
-COM2
COM2COM2
COM2
Press 7 to Set Contactless Com Port
Select the com port number to have the contactless reader connected to.
By default, com port NONE will be selected.
5.0
MULTI MERCHANT
MULTI MERCHANTMULTI MERCHANT
MULTI MERCHANT
SETUP
SETUPSETUP
SETUP
Terminal is now in configuration mode. Press CANCEL to exit, otherwise the
terminal will automatically exit after 30 seconds of inactivity