Ingenico 5100 - Merchant Administration Functions

SKYZER TECHNOLOGIES PAGE 79 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
4.13 MERCHANT ADMINISTRATION FUNCTIONS
The following standard merchant administration functions are available:
NOTE: When set up as a multi-merchant device, the terminal will first prompt for
the selection of the particular merchant for each of the administration
functions above.
4.13.1 Terminal Totals
This function allows the merchant to determine the total count and amount of
all accepted transactions supported by the terminal since the totals where last
reset by the merchant.
Step
Terminal Display
Description
1.0
ADMIN
ADMINADMIN
ADMIN
TOTL INQ CUT
TOTL INQ CUTTOTL INQ CUT
TOTL INQ CUT
Press ENTER until the ADMIN menu is shown on the display.
Press CHQ key to select TOTL.
2.0
1 Merchant 1
1 Merchant 11 Merchant 1
1 Merchant 1
2 Merchant 2
2 Merchant 22 Merchant 2
2 Merchant 2
3 Merchant 3
3 Merchant 33 Merchant 3
3 Merchant 3
Only applicable with Multi-Merchant setup.
Select the corresponding number on the terminal to select the Merchant followed by
ENTER.
3.0
PRINTING
PRINTINGPRINTING
PRINTING Totals will be printed immediately.
4.0
RESET TOTALS?
RESET TOTALS?RESET TOTALS?
RESET TOTALS?
ENTER=YES, CLR=NO
ENTER=YES, CLR=NOENTER=YES, CLR=NO
ENTER=YES, CLR=NO
The user will be prompted whether the totals should be reset.
- If yes is selected, the terminal will return to idle and totals will have been reset. (To
check this, repeat steps 1-2. Totals should all appear as $0.00 on the printout.)
- If no is selected, terminal will return to idle without resetting the totals. (To check
this, repeat steps 1-2. Totals should remain the same.)