SKYZER TECHNOLOGIES PAGE 27 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
3.2.1 Dial-Up Configuration
1.0
QUICK DIAL?
QUICK DIAL?QUICK DIAL?
QUICK DIAL?
1
11
1-
--
-YES 2
YES 2YES 2
YES 2-
--
-NO
NONO
NO
This parameter sets up the way that terminal dials. Select the mode by pressing the
corresponding number key.
2.0
DIAL MODE?
DIAL MODE?DIAL MODE?
DIAL MODE?
1
11
1-
--
-TONE
TONETONE
TONE
2
22
2-
--
-PULSE
PULSEPULSE
PULSE
3
33
3-
--
-TONE/BLIND
TONE/BLINDTONE/BLIND
TONE/BLIND
This parameter sets up the way that the terminal dials. Select the mode by pressing
the corresponding number key.
1 = Tone - is the default setting.
In the default dial mode setting 1 (Tone), the terminal uses DTMF tones to dial the
number, but only after detecting a valid NZ dial tone. If a valid dial tone isn’t
detected, “Transmission Error” will be displayed.
2 = Pulse Dial – this comms setting is used for the older PABX systems and is
rarely used nowadays.
3 = Blind Dial – this is the same as Tone dial, however the modem ignores the
health of the dial tone on the line and simply dials the configured phone number to
call the host. This is used where the quality of the dial tone is low.
3.0
PABX?
PABX?PABX?
PABX?
1
11
1A
AA
A
or
oror
or
1W
1W1W
1W
Press ENTER to bypass if no PABX prefix is required.
This parameter specifies the PABX numbers that the terminal dials to access an
outside line.
Note: The terminal pauses for 1 second after dialling if a control character ‘A’ is
inserted or to pauses for couple of seconds after dialling if a control character ‘W’ is
inserted after the PABX number. To insert a control character ‘A’ or ‘W’, press the
corresponding number key and then the FUNC key.
4.0
HOST PHONE NO?
HOST PHONE NO?HOST PHONE NO?
HOST PHONE NO?
08797
0879708797
08797
This parameter specifies the Phone number of the Paymark Host. By default, the
host phone number is set as 08797.
Press ENTER.
NOTE: If the merchant has the Toll Bar on the site, then key in this phone
number 1797 to obtain connectivity to Paymark network.
5.0
SAVE CONFIG Y/N
SAVE CONFIG Y/NSAVE CONFIG Y/N
SAVE CONFIG Y/N
Terminal prompts to save configuration. Press ENTER to save configuration on the
terminal or press CLEAR to exit and return to idle screen.
To Next Page
Loading...
