Ingenico 5100 - Multi Merchant Configuration Flowchart

SKYZER TECHNOLOGIES PAGE 25 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
3.1.5 Multi Merchant Configuration Flowchart
From the idle screen
press FUNC and
then key in 7418
followed by the
ENTER
Key in the required
active merchant
numbers followed by
the ENTER. Example, if 3
merchants are
required, then key in
123 followed by the
ENTER.
Key in the merchant 1
name followed by ENTER
and then merchant 2 and
so on until all merchants
names have been
assigned. Example: to key
in the names, press the
corresponding number
key once and then FUNC
to scroll through the
alpha characters.
From the MULTI
MERCHANT SETUP
screen, press 3 to set up
active merchants
From the MULTI
MERCHANT SETUP
screen, press 4 to
assign names for the
active merchants.
From the MULTI
MERCHANT SETUP screen,
press CANCEL to exit out
and return to idle screen.
START
Press ENTER at the
CONFIG PARAMS?
SELECT MERCHANT
1. MERCHANT 1
2. MERCHANT 2
3. MERCHANT 3
will be displayed.
Press the
corresponding
number key to select
the merchant
followed by ENTER.
To configure the
active merchants on
the terminal, from the
idle screen press FUNC
and then key in 3824
followed by the ENTER.
Key in the Terminal
and Merchant ID into
the terminal followed
by the ENTER.
Network Interface
Identifier (NII) by default
will be selected as 001
and press ENTER
At the COMMS MODE,
press the corresponding
number key to select
preferred comms mode
and press ENTER
1-Dial-up (page 26)
2-TCP-IP/Dial (page 27)
3-TCP-IP (page 29)
Refer to the page number
to configure the terminal
for selected comms
mode.