Ingenico 5100 - To Deactivate Multi-Merchant Configuration

SKYZER TECHNOLOGIES PAGE 35 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
3.4.2 To Deactivate Multi-Merchant Configuration
This function allows the merchant to deactivate multi-merchants on the
terminal if not required.
Step
Terminal D
isplay
Description
1.0
Press FUNC
2.0
FUNCTION?
FUNCTION?FUNCTION?
FUNCTION? Enter 7418, press ENTER
3.0
MULTI MERCHANT
MULTI MERCHANTMULTI MERCHANT
MULTI MERCHANT
SETUP
SETUPSETUP
SETUP
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
4.0
ACTIVE MERCHANTS
ACTIVE MERCHANTSACTIVE MERCHANTS
ACTIVE MERCHANTS
1
11
1
Press 3 to Deactivate A
ctive Merchants
Terminal will display with all active merchants that was previous configured. To
deactivate multi-merchant from the terminal, key in the active merchant number
that the merchant desire to have active followed by the ENTER. This will result in
deactivating the other active merchants on the terminal.
Example: To deactivate merchants 2 to 5, enter the merchant number 1 to have
active and other active merchants will be deactivated.
5.0
MULTI MERCHANT
MULTI MERCHANTMULTI MERCHANT
MULTI MERCHANT
SETUP
SETUPSETUP
SETUP
Terminal is now in configuration mode. Press CANCEL to exit, otherwise the
terminal will automatically exit after 30 seconds of inactivity