Ingenico 5100 - Settlement Cutover

SKYZER TECHNOLOGIES PAGE 81 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
4.13.3 Settlement Cutover
This function allows the merchant to settle the current settlement period and to
cut over to a new settlement period. This can only be performed successfully
when the terminal is within the ‘settlement window’ defined by Paymark for the
particular merchant and terminal.
Step
Terminal Display
Description
1.0
ADMIN
ADMINADMIN
ADMIN
TOTL INQ CUT
TOTL INQ CUTTOTL INQ CUT
TOTL INQ CUT
Press ENTER until ADMIN menu is shown on the display.
Press CR key to select CUT.
2.0
1 Merchant 1
1 Merchant 11 Merchant 1
1 Merchant 1
2 Merchant 2
2 Merchant 22 Merchant 2
2 Merchant 2
3 Merchant 3
3 Merchant 33 Merchant 3
3 Merchant 3
Only applicable with Multi-Merchant setup.
Select the corresponding number on the terminal to select the Merchant followed by
ENTER.
3.0
CUTOV
CUTOVCUTOV
CUTOVER NOW?
ER NOW?ER NOW?
ER NOW?
ENTER=YES, CLR=NO
ENTER=YES, CLR=NOENTER=YES, CLR=NO
ENTER=YES, CLR=NO
Press ENTER to initiate a settlement cutover or CLEAR to cancel and return to the
previous state.
NOTE: Terminal will prompt for any stored Tip Transactions and/or Electronic Offline
Voucher to be transmitted. Press ENTER to transmit or press CLEAR to proceed with
settlement cutover.
4.0
PROCESSING NOW
PROCESSING NOWPROCESSING NOW
PROCESSING NOW PROCESSING NOW will be displayed on the terminal while processing the
transaction.
5.0
TRANS. COMPLETE
TRANS. COMPLETETRANS. COMPLETE
TRANS. COMPLETE Settlement cutover record is printed.
NOTE: Any stored Tipping, EOV offline and/or Contactless transactions, will be
prompted to upload when Settlement Cutover is performed. To upload these
stored transactions at that time, press ENTER or CLEAR to cancel upload and
proceed with Settlement Cutover.