SKYZER TECHNOLOGIES PAGE 39 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
3.7 REMOTE KEY INJECTION (PKMS)
The Ingenico 5100 terminal supports Remote Key Injection technology to
enable automated injection of security keys from Paymark.
3.7.1 Remote Key Injection (PKMS) Configuration
This function is used to configure the Remote Key Injection operation and can
be performed through both Dial-up and TCP-IP (Broadband) mode.
3.7.1.1 Dial-up Configuration
1.0
Press FUNC
2.0
FUNCTION?
FUNCTION?FUNCTION?
FUNCTION?
Enter 7418, press ENTER
3.0
MULTI MERCHANT
MULTI MERCHANTMULTI MERCHANT
MULTI MERCHANT
SETUP
SETUPSETUP
SETUP
Terminal is now in configuration mode. Go to following Steps to proceed or Press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
4.0
MULTI MERCHANT
MULTI MERCHANTMULTI MERCHANT
MULTI MERCHANT
SETUP
SETUPSETUP
SETUP
Select option 5 for RKI configuration by pressing the corresponding number key.
5.0
RKI
RKIRKI
RKI
CONFIG?
CONFIG?CONFIG?
CONFIG?
ENTER OR CLEAR
ENTER OR CLEARENTER OR CLEAR
ENTER OR CLEAR
Press ENTER to proceed with the RKI configuration or CLEAR to cancel and exit to
idle screen
6.0
NII?
NII?NII?
NII?
018
018018
018
This parameter specifies the Network International Identifier that the terminal uses
to route messages to Paymark.
Press ENTER.
7.0
RKI
RKIRKI
RKI
PHONE NO?
PHONE NO?PHONE NO?
PHONE NO?
08797
0879708797
08797
This parameter specifies the Phone number of the Paymark Host, where it will be
connecting to download the keys. By default, the RKI phone number is set as
08797.
NOTE: If the merchant has the Toll Bar on the site, then key in this phone
number 1797 to obtain connectivity to Paymark network.
8.0
MULTI MERCHANT
MULTI MERCHANTMULTI MERCHANT
MULTI MERCHANT
S
SS
SETUP
ETUPETUP
ETUP
Terminal is now in configuration mode. Press CANCEL to exit, otherwise the
terminal will automatically exit after 30 seconds of inactivity
To Next Page
Loading...
