Ingenico 5100 - Master Memory Reset

SKYZER TECHNOLOGIES PAGE 34 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
3.4.1 Master Memory Reset
This function allows the merchant to reset the memory of the entire active
merchants on the terminal.
Step
Terminal Display
Description
1.0
Press FUNC
2.0
FUNCTION?
FUNCTION?FUNCTION?
FUNCTION? Enter 7418, press ENTER
3.0
MULTI MERCHANT
MULTI MERCHANTMULTI MERCHANT
MULTI MERCHANT
SETUP
SETUPSETUP
SETUP
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
4.0
DELETE CONFIG?
DELETE CONFIG?DELETE CONFIG?
DELETE CONFIG?
ENTER=YES,CLR=NO
ENTER=YES,CLR=NOENTER=YES,CLR=NO
ENTER=YES,CLR=NO
Press 8 to Delete Terminal Configuration
To delete the Terminal Configuration of the entire active merchants, press ENTER
or CLEAR to return to MULTI MERCHANT SETUP screen.
4.1
ARE YOU SURE?
ARE YOU SURE?ARE YOU SURE?
ARE YOU SURE?
ENTER=YES, CLR=NO
ENTER=YES, CLR=NOENTER=YES, CLR=NO
ENTER=YES, CLR=NO
Press ENTER to proceed with deleting the entire active merchants terminal
configuration or CLEAR to return to MULTI MERCHANT SETUP screen.
4.2
ETSL
ETSLETSL
ETSL EFTPOS
EFTPOSEFTPOS
EFTPOS
MEMORY RESET
MEMORY RESETMEMORY RESET
MEMORY RESET
This message will be displayed on the terminal for few seconds when resetting the
memory to factory default.
5.0
MULTI MERCHANT
MULTI MERCHANTMULTI MERCHANT
MULTI MERCHANT
SETUP
SETUPSETUP
SETUP
Terminal is now in configuration mode. Press CANCEL to exit, otherwise the
terminal will automatically exit after 30 seconds of inactivity