Ingenico 5100 - Configure Receipt Header and Footer

SKYZER TECHNOLOGIES PAGE 44 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
3.9 CONFIGURE RECEIPT HEADER AND FOOTER
This function allows the merchant to customize the receipt merchant name
and address lines.
NOTE: The footer lines will only be printed off on the customer copy of the
receipt.
Step
Terminal Display
Comment
1.0
Press FUNC
2.0
FUNCTION?
FUNCTION?FUNCTION?
FUNCTION? Enter 3825, press ENTER
3.0
CONFIG RECEIPT
CONFIG RECEIPTCONFIG RECEIPT
CONFIG RECEIPT
HEADER & FOOTER?
HEADER & FOOTER?HEADER & FOOTER?
HEADER & FOOTER?
ENTER OR CLEAR
ENTER OR CLEARENTER OR CLEAR
ENTER OR CLEAR
Press ENTER to configure the parameters or CLEAR to cancel and return to idle
screen
4.0
ERASE EXISTING
ERASE EXISTINGERASE EXISTING
ERASE EXISTING
HEADER & FOOTER?
HEADER & FOOTER?HEADER & FOOTER?
HEADER & FOOTER?
ENTER OR CLEAR
ENTER OR CLEARENTER OR CLEAR
ENTER OR CLEAR
Only applicable if header and footer was previously configured
Press ENTER to erase the existing header and footer that were previously
configured on the terminal or CLEAR to keep the previous configuration and make
minor alteration to the header and footer.
5.0
M
MM
MERCHANT NAME
ERCHANT NAMEERCHANT NAME
ERCHANT NAME
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
This parameter specifies the Merchant Name. It can be configured by entering the
desired Merchant Name use the numeric keypads then the FUNC key to access the
alpha characters then press ENTER
Note: Up to 20 characters can be entered per line.
6.0
ADDRESS LINE 1
ADDRESS LINE 1ADDRESS LINE 1
ADDRESS LINE 1
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
This parameter specifies the address in which you would like to appear on printed
receipt. It can be configured by entering desired address use the numeric keypads
then the FUNC key to access the alpha characters then press ENTER
NOTE: Two address lines can appear on printed receipted
Example: Address Line 1 - 1066 COOKS RD
7.0
ADDRESS LINE 2
ADDRESS LINE 2ADDRESS LINE 2
ADDRESS LINE 2
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
This parameter specifies the address in which you would like to appear on printed
receipt. It can be configured by entering desired use the numeric keypads then the
FUNC key to access the alpha characters then press ENTER
Example: Address Line 2 - PENROSE
8.0
FOOTER LINE 1
FOOTER LINE 1FOOTER LINE 1
FOOTER LINE 1
XXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXX
This parameter allows up to ten lines of text to be printed at the bottom of the
cardholder’s copy of the receipt.
It can be configured by entering desired footer use the numeric keypads then the
FUNC key to access the alpha characters then press ENTER