Ingenico 5100 - EFTPOS Configuration Options

SKYZER TECHNOLOGIES PAGE 26 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
3.2 EFTPOS CONFIGURATION
The EFTPOS Configuration option enables the terminal to be configured to
operate as an EFTPOS terminal and must be done before the terminal can
process transactions.
Step
Terminal Disp
lay
Comment
1.0
Press FUNC
2.0
FUNCTION
FUNCTIONFUNCTION
FUNCTION?
??
? Enter 3824 and press ENTER.
3.0
CONFIG PARAMS?
CONFIG PARAMS?CONFIG PARAMS?
CONFIG PARAMS?
ENTER OR CLEAR
ENTER OR CLEARENTER OR CLEAR
ENTER OR CLEAR
ENTER to configure the parameters, CLEAR to cancel and exit to idle prompt.
4.0
TERMINAL ID?
TERMINAL ID?TERMINAL ID?
TERMINAL ID?
XXXXXXXX
XXXXXXXXXXXXXXXX
XXXXXXXX
This parameter specifies the Terminal ID that Paymark assigns to the terminal.
Press ENTER.
5.0
MERCHANT ID?
MERCHANT ID?MERCHANT ID?
MERCHANT ID?
XXXXXXXXX
XXXXXXXXXXXXXXXXXX
XXXXXXXXXXX
XXXX
XX
This parameter specifies the Merchant ID assigned by Paymark.
Press ENTER.
6.0
NII?
NII?NII?
NII?
001
001001
001
This parameter specifies the Network International Identifier (by default 001) that
the terminal uses to route messages to Paymark.
Press ENTER.
7.0
COMMS MODE?
COMMS MODE?COMMS MODE?
COMMS MODE?
1
11
1-
--
-DIAL
DIALDIAL
DIAL-
--
-UP
UPUP
UP
To configure COMMS mode:
Press 1 for Dial-up configuration followed by ENTER and proceed with the
configuration as on page 27.
7.1
COMMS MODE?
COMMS MODE?COMMS MODE?
COMMS MODE?
2
22
2-
--
-TCP
TCPTCP
TCP-
--
-I
II
IP / Dial
P / DialP / Dial
P / Dial
Press 2 for TCP-IP /Dial backup configuration followed by ENTER and proceed
with the configuration as on page 28 - 29.
7.2
COMMS MODE?
COMMS MODE?COMMS MODE?
COMMS MODE?
3
33
3-
--
-TCP
TCPTCP
TCP-
--
-IP
IPIP
IP
Press 3 for TCP-IP configuration followed by ENTER and proceed with the
configuration as on page 30.