SKYZER TECHNOLOGIES PAGE 31 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
3.3 EFTPOS CONFIGURATION FOR MULTI-MERCHANT
For a multi-merchant terminal each merchant has its own configuration.
Prior to configuring the terminal for multi-merchant, refer to page 30 to setup
the required number of active merchants on the terminal. Once assigned then
proceed with the following steps to configure the terminal for multi merchant.
1.0
Press FUNC
2.0
FUNCTION?
FUNCTION?FUNCTION?
FUNCTION?
Enter 3824 and press ENTER.
3.0
CONFIG PARAMS?
CONFIG PARAMS?CONFIG PARAMS?
CONFIG PARAMS?
ENTER OR CLEAR
ENTER OR CLEARENTER OR CLEAR
ENTER OR CLEAR
ENTER to configure the parameters, CLEAR to cancel and exit to idle prompt.
4.0
1 MERCHANT 1
1 MERCHANT 11 MERCHANT 1
1 MERCHANT 1
2 MERCHANT 2
2 MERCHANT 22 MERCHANT 2
2 MERCHANT 2
3 MERCHANT 3
3 MERCHANT 33 MERCHANT 3
3 MERCHANT 3
Select the corresponding number on the terminal to select the Merchant to proceed
with configuration followed by ENTER.
5.0
TERMINAL ID?
TERMINAL ID?TERMINAL ID?
TERMINAL ID?
XXXXXXXX
XXXXXXXXXXXXXXXX
XXXXXXXX
This parameter specifies the Terminal ID that Paymark assigns to the terminal.
Press ENTER.
6.0
MERCHANT ID?
MERCHANT ID?MERCHANT ID?
MERCHANT ID?
XXXXXXXXXXX
XXXXXXXXXXXXXXXXXXXXXX
XXXXXXXXXXX
This parameter specifies the Merchant ID assigned by Paymark.
Press ENTER.
7.0
NII?
NII?NII?
NII?
001
001001
001
This parameter specifies the Network International Identifier (by default 001) that
the terminal uses to route messages to Paymark.
Press ENTER.
8.0
COMMS MODE?
COMMS MODE?COMMS MODE?
COMMS MODE?
1
11
1-
--
-DIAL
DIALDIAL
DIAL-
--
-UP
UPUP
UP
To configure COMMS mode:
Press 1 for Dial-up configuration followed by ENTER and proceed with the
configuration as on page 27.
8.1
COMMS MODE?
COMMS MODE?COMMS MODE?
COMMS MODE?
2
22
2-
--
-TCP
TCPTCP
TCP-
--
-IP
IPIP
IP
/ DIAL
/ DIAL/ DIAL
/ DIAL
Press 2 for TCP-IP /Dial backup configuration followed by ENTER and proceed
with the configuration as on page 28 - 29.
8.2
COMMS MODE?
COMMS MODE?COMMS MODE?
COMMS MODE?
3
33
3-
--
-TCP
TCPTCP
TCP-
--
-IP
IPIP
IP
Press 3 for TCP-IP configuration followed by ENTER and proceed with the
configuration as on page 30.
Proceed with the configuration as normal, until CONFIG TO ALL MERCHANT Y/N
prompt and proceed as below.
To Next Page
Loading...
