Ingenico 5100 - Terminal Setup and Configuration; Configuration Flowchart

SKYZER TECHNOLOGIES PAGE 21 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
3 SET UP
3.1 CONFIGURATION FLOWCHART
3.1.1 Overview: Procedure to Activate Paymark Terminal
NOTE: The Remote Key Injection (PKMS) can be performed through dial up and
broadband connection. Once the PKMS initialisation is successful, restart the
terminal and then a merchant logon can be initiated to obtain connectivity to
Paymark network.
TERMINAL CONFIGURATION
FUNC 3824
Configure the Terminal ID
and select preferred COMMS
mode.
1 – Dial up (Page 19)
2 – TCP-IP/Dial up (Page 20)
3 – TCP-IP (Page 21)
PKMS INITIALISATION
(Page 33)
Press FUNC 87 and then
key in the PKMS
password 6987 followed
by ENTER. Terminal will
display REMOTE INIT IN
PROGRESS followed by
ACCEPTED when
successful. Press FUNC
86 followed by ENTER
twice to restart the
terminal.
START
TERMINAL
CONFIGURATION
RECEIPT (Page 73)
Press ENTER to scroll
through until
SUPERVISOR menu is
displayed. Press the
CHQ to select XTRA to
perform TERMINAL
FUNCTIONS. Press
number 2 to display
KVC download on to
the terminal. Press ENTER
to print off the terminal
configuration receipt.
OPTIONAL
MERCHANT LOGON
(Page 37)
Press ENTER to scroll
through until
SUPERVISOR menu is
displayed. Press the SAV
to select INIT to perform
a logon.
MANUALLY KEY LOADED
If the terminal is
manually key loaded
then the merchant
needs to register the
keyset (which is located
at the back of the
terminal on Paymark
sticker) against the
terminal ID by
contacting the
Paymark helpdesk on
0800 800 996