Ingenico 5100 - TCP-IP (Broadband) Configuration Flowchart

SKYZER TECHNOLOGIES PAGE 24 OF 97
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE Version 1.3
At the COMMS MODE,
press the corresponding
number key to select
preferred comms mode
and press ENTER
1-Dial-up
2-TCP-IP/Dial
3-TCP-IP
3.1.4 TCP-IP (Broadband) Configuration Flowchart
From the idle screen
press FUNC and
then key in 3824
followed by the
ENTER
Key in the Terminal and
Merchant ID into the
terminal followed by
the ENTER.
Press ENTER at the
CONFIG PARAMS?
Network Interface
Identifier (NII) by
default will be selected
as 001 and press ENTER
If TCP-IP is selected, the
Primary Host IP address
is set as default
117.120.34.110, press
ENTER.
Primary Host Port
number is set as default
to 33876
, press
ENTER
.
START
YES
NO
COMPLETED
START TCP-IP Y/N?
Press ENTER to start
TCP-IP or CLEAR to exit
without starting TCP-IP
Save Config Y/N?
Press ENTER to save
or CLEAR to exit
without saving
At the Enable DHCP Y/N, by
default is selected as 1-YES
and press ENTER, if the site
has DHCP
If the site has no DHCP
enabled, press 2-NO and
then press ENTER
Manually key in the
• Static IP address
• Subnet Mask
• Gateway IP
address
The Secondary Host IP
address is set as default
117.120.32.110, press
ENTER.
Secondary Host Port
number is set as default
to 33876
, press
ENTER
.