Ingenico i6780 - Chapter 12 Download Errors; Error Opening Port; Communications Port that IBMEFTDL Is Using Is Already Being Used by Another Application; Communications Port Is Not Working

Chapter 12
Download Errors
12.1 Error Opening Port
This error message displays on the computer or cash register. The following sections list
possible causes and corresponding solutions.
12.1.1 Communications port that IBMEFTDL is using is already being
used by another application
Close the other application and run the download file again.
12.1.2 Communications port is not working
 Try another computer.
 Ask your Ingenico representative to change the batch file to work with the new
communications port. Change to the new communications port, then run the new
batch file.
12.1.3 Hardware settings in i6780 have been changed
1. Check the properties of the communications port to make sure that the interrupt
request and input/output range has not been changed. In Windows 98 or 2000:
a. Right-click My Computer, then select Properties.
b. Click the
Device Manager tab.
c. From the list, double-click
Ports, double-click Communications Ports, and then
go to the
Resources tab.
2. Ensure the settings for COM1 are the default, as follows:
 Interrupt Request is 04

Input/Output Range is 03F8
3.
Ensure the settings for COM2 are the default, as follows:

Interrupt Request is 03

Input/Output Range is 02F8
106 Chapter 12 Download Errors
Section 12.1 Error Opening Port