Ingenico i6780 - Testing the SAMs

7.10 Testing the SAMs
This feature tests communication between the SAM slots and the SAM micro-controller (SMC).
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Using the stylus, tap
Diagnostic Menu.
Serialnum Inject
System Config
System Info
Supervisor Menu
Diagnostic Menu
Diagnostic Menu
Display
Keypad
Beeper
RS232
Tailgate
USB
Mag Stripe Reader
Smart Card Reader
SAM
Tap
SAM.
SAM
Found SAM Slot1.
Found SAM Slot2.
Found SAM Slot3.
Found SAM Slot4.
SAM
ATR means answer to reset.
Check Slot2 ATR
Read data from Slot2
(Result)
SAM
Power off all slots
Close all smc slots
SMC stands for SAM micro-controller.
74 Chapter 7 Diagnostic Menu
Section 7.10 Testing the SAMs