Using your finger, touch the four-box grid. The
box moves around to the next corner; touch
again.
Tip: For the calibration to succeed, you need to
touch the buttons from the side: Touch the left
buttons with your left hand and the right buttons
with your right hand.
Repeat until you are notified that the test was
successful.
Calibrate Finger
Please touch box
You are notified if the finger calibration was
successful.
If calibration failed, try again, making sure to
follow the preceding tip.
Calibrate Finger
Calibration Succeeded!
7.15 SCV Verification (Ingenico use only)
This test is used by the manufacturer, authorized repair centers, and deployment centers to
verify that the correct configuration has been loaded for the customer.
You can find the same information by going to the
System Info menu and selecting Version
Numbers
(for details, see “Finding Version Numbers” on page 18).
Ingenico 6780 User’s Guide 79
To Next Page
Loading...
