Ingenico i6780 - Defining the Local IP Address

DHCP
Select None or Auto, and then press [Enter].
None
Auto
Updating
6.4.12 Defining the Local IP Address
If your terminal is using Ethernet, and DHCP is set to None, you will need to configure the
local IP address, which identifies the terminal on the network. Each machine connected to the
Internet has an address known as an Internet Protocol address (IP address). The IP address
takes the form of four numbers separated by dots, for example: 192.168.0.5.
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Using the stylus, tap
Supervisor Menu.
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Tap
Sys Parameters.
Sys Parameters
Download Method
Download Port
Setup Port
Tap
Setup Port.
Setup Port
Port1
Port2
Port3
Tap
Port3, Ethernet.
Port3
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
DHCP
Local IP
Tap
Local IP.
Ingenico 6780 User’s Guide 51