Ingenico i6780 - Defining the LAN Address

6.4.6 Defining the LAN Address
Use this procedure if you are connecting your terminal to a local area network (LAN) through
the Host or Aux port.
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Using the stylus, tap
Supervisor Menu.
Serialnum Inject
System Config
System Info
Supervisor Menu
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Tap
Sys Parameters.
Sys Parameters
Download Method
Download Port
Setup Port
Tap
Setup Port.
Setup Port
Port1
Port2
Select Port1 or Port2.
(By default, Port 1 = Host, Port 2 = Aux.)
Port X
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
LAN Address
Tap
LAN Address.
LAN Address
Old Value: 104
Enter New Value:
Key the appropriate LAN address, then press
[Enter].
Ingenico 6780 User’s Guide 45