Ingenico i6780 - Setting up the Port; Selecting the Download Interface Type

6.4 Setting Up the Port
6.4.1 Selecting the Download Interface Type
Use this procedure to select RS232, RS485, Ethernet, etc. as the interface type for Port1
(Host), Port2 (Aux), or Port3 (Ethernet).
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
Using the stylus, tap
Supervisor Menu.
System Config
System Info
Supervisor Menu
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Tap
Sys Parameters.
Sys Parameters
Download Method
Download Port
Setup Port
Tap
Setup Port.
Download Port
Port1
Port2
Port3
Dial
Host Port
Aux Port
Tap
Port1, Port2, or Port3.
(By default, Port 1 = Host, Port 2 = Aux, Port 3 =
E-NET port - Ethernet.)
PortX
Interface Type
Baud Rate
Data Bits
Press [Enter] to select
Interface Type.
PortX
Auto Detect Result
RS232
RS485
Select the communications method you want. If
you select Port 1 and Auto Detect Result, the
application will detect the communications type of
a cable plugged into the selected port and return
that information to you.
40 Chapter 6 System Parameters Menu
Section 6.4 Setting Up the Port