Ingenico i6780 - Setting the Retry Count

6.4.7 Setting the Retry Count
This option sets the number of times the COM port should retry communications in the event
of failure (0 to 10).
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
Using the stylus, tap
Supervisor Menu.
System Config
System Info
Supervisor Menu
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Tap
Sys Parameters.
Sys Parameters
Download Method
Download Port
Setup Port
Tap
Setup Port.
Setup Port
Port1
Port2
Port3
Select
Port1 or Port2.
(By default, Port 1 = Host, Port 2 = Aux.)
Port X
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
LAN Address
Retry Count
Tap
Retry Count.
Retry Count
Old Value: 4
Enter New Value:
Enter the number of times the COM port should
retry in the event of failure (0 to 10).
46 Chapter 6 System Parameters Menu
Section 6.4 Setting Up the Port