7.13 Testing Pen Calibration
Your terminal was calibrated by the manufacturer and you will not need to recalibrate it. This
feature is for use by repair facilities. If they replace the glass on the display screen, or if they
run a production test application, they need to recalibrate the terminal.
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
System Config
Using the stylus, tap
Diagnostic Menu.
System Info
Supervisor Menu
Diagnostic Menu
Diagnostic Menu
Display
Keypad
Beeper
RS232
Tailgate
USB
Mag Stripe Reader
Smart Card Reader
SAM
Touch Screen
Signature Capture
Pen Calibration
Tap ▼ until you reach Pen Calibration, then tap
Pen Calibration.
Please remove hands/objects
from around the display
Calibration will start in 3
seconds…
Using the stylus, tap the four-box grid. The box
moves around to the next corner; tap again.
Repeat until you are notified if the test was
successful.
Calibrate Pen
Please tap box
Ingenico 6780 User’s Guide 77
To Next Page
Loading...
