Ingenico i6780 - Setting the Stop Bits

6.4.4 Setting the Stop Bits
Set the stop bits according to the host requirements.
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
Using the stylus, tap
Supervisor Menu.
System Config
System Info
Supervisor Menu
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Tap
Sys Parameters.
Sys Parameters
Download Method
Download Port
Setup Port
Tap
Setup Port.
Setup Port
Port1
Port2
Port3
Select
Port1, Port2, or Port3.
(By default, Port 1 = Host, Port 2 = Aux, Port 3 =
E-NET port - Ethernet.)
Set Port X
Interface Type
Baud Rate
Data Bits
Stop Bits
Tap
Stop Bits.
Stop Bits
1
2
Select the appropriate stop bits value.
Updating
Ingenico 6780 User’s Guide 43