6.4.5 Setting the Parity
Set the parity according to the host requirements.
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Tap
Supervisor Menu.
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Using the stylus, tap
Sys Parameters.
Sys Parameters
Download Method
Download Port
Setup Port
Tap
Setup Port.
Setup Port
Port1
Port2
Port3
Select
Port1, Port2, or Port3.
(By default, Port 1 = Host, Port 2 = Aux, Port 3 =
E-NET port - Ethernet.)
Set Port X
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
Tap
Parity.
Parity
None
Odd
Even
Select the appropriate parity.
44 Chapter 6 System Parameters Menu
Section 6.4 Setting Up the Port
To Next Page
Loading...
