Ingenico i6780 - Configuring the Host Port Auto Detect Feature; Disabling or Enabling the Auto Detect Feature

Sys Parameters
Tap
Setup Port.
Download Method
Download Port
Setup Port
Setup Port
Tap
Host or Aux port, and then press [Enter].
Port1
Port2
Port3
Dial
Host Port
Aux Port
Dial
COM1
COM2
COM3
Select the port you want.
By default, COM1 = Host, COM2 = Aux, COM3 =
Ethernet.
Updating
6.5 Configuring the Host Port Auto Detect Feature
By default, the Host port is set to automatically detect the communications method being used
on that port: RS232, RS485 IVI LAN protocol, RS485 Tailgate protocol, USB, or PoweredUSB.
6.5.1 Disabling or Enabling the Auto Detect Feature
When the auto detect feature is enabled on the host port, it will automatically detect the
communications method being used on that port. By default, the Host port’s Auto Detect
feature is enabled.
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Using the stylus, tap
Supervisor Menu.
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Tap
Sys Parameters.
62 Chapter 6 System Parameters Menu
Section 6.5 Configuring the Host Port Auto Detect Feature