Port3
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
DHCP
Local IP
Local IP Port
Server IP
Server IP Port
IP Add Mask
Tap ▼ until you reach IP Add Mask, then tap
IP
Add Mask
(IP address mask or subnet mask).
IP ADD MASK
XXX.XXX.XXX.XXX
Enter the subnet mask.
Updating
6.4.17 Setting the Gateway
If you are using Ethernet, you will need to enter the IP address of the gateway server. A
gateway is a router; it is a specific host on the network which can transmit requests from one
network to another, in this case from the Ethernet network to the Internet and back again. In
many cases, this will be the subnet with a “.1” address (i.e., 192.168.1.1).
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Using the stylus, tap
Supervisor Menu..
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Tap
Sys Parameters.
Sys Parameters
Download Method
Download Port
Setup Port
Tap
Setup Port.
56 Chapter 6 System Parameters Menu
Section 6.4 Setting Up the Port
To Next Page
Loading...
