Ingenico i6780 - Setting the Turnaround Timeout

6.4.10 Setting the Turnaround Timeout
The Turnaround Timeout indicates the time a concentrator or a hub will wait between its
request for data and a device's response in a poll sequence.
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
Using the stylus, tap
Supervisor Menu.
System Config
System Info
Supervisor Menu
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Tap
Sys Parameters.
Sys Parameters
Download Method
Download Port
Setup Port
Tap
Setup Port.
Setup Port
Port1
Port2
Select Port1 or Port2.
(By default, Port 1 = Host, Port 2 = Aux.)
Port X
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
LAN Address
Retry Count
Response TMO
Poll TMO
Turnaround TMO
Tap
Turnaround TMO.
Turnaround TMO
Old Value: 300
Enter New Value:
Enter an amount of time after which the port
should cease turnaround, in units of 1/100 of a
second.
Ingenico 6780 User’s Guide 49