Ingenico i6780 - Setting the Local IP Port Number

Local IP
192.168.0.5
Enter the local IP address.
6.4.13 Setting the Local IP Port Number
If your terminal is using Ethernet, and DHCP is set to None, you will need to configure the
local IP port for the terminal to use. This is a number that is used in TCP/IP applications to
designate which application the device is communicating with.
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Using the stylus, tap
Supervisor Menu..
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Tap
Sys Parameters.
Sys Parameters
Download Method
Download Port
Setup Port
Tap
Setup Port.
Setup Port
Port1
Port2
Port3
Tap
Port3, Ethernet.
Port3
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
DHCP
Local IP
Local IP Port
Tap Local IP Port.
52 Chapter 6 System Parameters Menu
Section 6.4 Setting Up the Port