Ingenico i6780 - Setting the Primary DNS

Setup Port
Port1
Port2
Port3
Tap
Port3, Ethernet.
Port3
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
DHCP
Local IP
Local IP Port
Server IP
Server IP Port
IP Add Mask
Gateway
Tap ▼ until you reach Gateway, then tap
Gateway.
Gateway
XXX.XXX.XXX.XXX
Enter the address of the gateway.
Updating…
6.4.18 Setting the Primary DNS
If you are using Ethernet, and DHCP is set to None, you will need to enter the primary Domain
Name Service (DNS). This is used to change Internet domain names and computer names
into IP addresses and vice versa. DNS specifications require that each domain name is served
by at least two DNS servers for redundancy, a primary and secondary.
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Using the stylus, tap
Supervisor Menu.
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Tap
Sys Parameters.
Ingenico 6780 User’s Guide 57