Ingenico i6780 - Setting the Auto Detect Retry Times

AD Timeout
Old Value: XXXXXXXXX
Enter the amount of time after which the unit will
cease trying to automatically detect the
communications in the Port 1, in units of 1/100 of a
second.
Enter New Value:
_QZ ABC DEF
GHI JKL MNO
PRS TUV WXY
CAN
CLR
E
N
T
E
R
1
23
456
78
9
0
*# , .
6.5.3 Setting the Auto Detect Retry Times
mes the terminal will attempt a
et to 3,
,
t
The Auto Detect Retry Times indicates how many ti
communications protocol before trying the next one on the list. For example, if it is s
when the terminal starts up, it will try 3 times to connect to the HOST in USB mode. If it fails
then it will try 3 times to connect to the HOST in RS485 mode. If it fails, then it will try 3 times
to connect to the host in Tailgate mode. If it fails, then it will decide that COM1 is working in
RS232 mode. Therefore, the less retry times, the less amount of time it will take to auto-detec
the communications type.
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum
Inject
System Config
System Info
Supervisor Menu
.
Using the stylus, tap Supervisor Menu
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change
Tap Sys Parameters.
Password
Application File
Security
Sys Parameters
Sys Parameters
Downloa
d Method
Download Port
Setup Port
Auto Detect
Tap Auto Detect.
64 Chapter 6 System Parameters Menu
Section 6.5 Configuring the Host Port Auto Detect Feature