You are notified if the calibration succeeded or
failed.
Calibrate Pen
Calibration Succeeded!
7.14 Testing Finger Calibration
Your terminal was calibrated by the manufacturer and you will not need to recalibrate it. This
feature is for use by repair facilities. If they replace the glass on the display screen, or if they
run a production test application, they need to recalibrate the terminal.
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Diagnostic Menu
Using the stylus, tap
Diagnostic Menu.
Diagnostic Menu
Display
Keypad
Beeper
RS232
Tailgate
USB
Mag Stripe Reader
Smart Card Reader
SAM
Touch Screen
Signature Capture
Pen Calibration
Finger Calibration
Tap ▼ until you reach Finger Calibration, then
tap
Finger Calibration.
Please remove
hands/objects from
around the display,
calibration will start in 3
seconds…
78 Chapter 7 Diagnostic Menu
Section 7.14 Testing Finger Calibration
To Next Page
Loading...
