76800
115200
Updating
Press [Cancel] to return to the previous menu.
6.4.3 Setting the Data Bits
Set the data bits according to the host requirements.
Display Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Extended Menu
Serialnum Inject
Using the stylus, tap
Supervisor Menu.
System Config
System Info
Supervisor Menu
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Tap
Sys Parameters.
Sys Parameters
Download Method
Download Port
Setup Port
Tap
Setup Port.
Setup Port
Port1
Port2
Port3
Select
Port1, Port2, or Port3.
(By default, Port 1 = Host, Port 2 = Aux, Port 3 =
E-NET port - Ethernet.)
Port X
Interface Type
Baud Rate
Data Bits
Stop Bits
Tap
Data Bits.
Data Bits
5
6
7
8
Select the appropriate data bits value.
Updating
42 Chapter 6 System Parameters Menu
Section 6.4 Setting Up the Port
To Next Page
Loading...
