ESim v5.12 for EasyCoder PD4—Programmer’s Reference Manual 23
Chapter 5—Editing in Form Edit Mode
Place a Combination of Fixed Data and a Counter
e next command line is a text line containing fixed data and the coun-
ter (C0). e first time this label form is retrieved for printing, the start
value for this counter must be sent to the printer. e printer will store
the value of the counter for this form and automatically continue to print
the next value the next time this form is retrieved. Reset or set to another
value by sending a new start value.
Note: e value of the counter will be kept in the memory even
if another form is retrieved or the printer is switched off.
Command Explanation
A24,312,0,4,1,1,N,"SERIAL#: "C 0
↵
Text line, fixed data + 1:st counter
Place a Bar Code with Fixed Data and a Counter
Below a Bar Code Command line is used to enter a Code 128 bar code,
containing the fixed data "S" in combination with the actual counter
value. It is also set for printing the human readable text below the bar
code.
Note: e narrow to wide ratio is not relevant for Code 128.
e printer will use the value for the narrow bar to define the
bar code. (Value 3 for wide bar definition is ignored.)
Command Explanation
B280,440,0,1,2,3,96,B,"S"C 0
↵
Bar code, fixed data + 1:st counter
Place Graphics
e next line writes a graphic named "Intermec" from memory and posi-
tions it on the form.
Command Explanation
GG24,12,"LOGO"↵
Write graphic from graphics memory
End Programming of this Form
e closing command that flags the end of form, see the full program list-
ing later in this chapter.
Command Explanation
FE↵
Closing command to store form
To Next Page
Loading...
Need help?
General
