EasyManuals Logo

Intermec EasyCoder PX4i User Manual

Intermec EasyCoder PX4i
186 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #108 background imageLoading...
Page #108 background image
Chapter 8 — Intermec Shell Startup Program
EasyCoder PX4i Bar Code Label Printer User’s Guide (Fingerprint Version) 93
Software Update (downloading data from a host to a
CompactFlash card in the printer, upgrading the printers
firmware from a Compact- Flash card, or upgrading the
printer’s firmware from a file in a PC)
Reboot (restarting the printer)
Starting with Intermec Shell
A few seconds after you have switched on the power to the
printer and the initialization is completed, the countdown menu
of the Intermec Shell program will be displayed:
Now you have 5 seconds to enter Intermec Shell by pressing
Enter. The lower line tells you how much time you have left.
Should the time run out before you have taken any action, the
last selected application in Intermec Shell will be opened. If you
use the same application all the time, you will only need to switch
on the power, once the application has been selected.
If no other application has yet been selected, the current version
of Intermec Fingerprint will be opened with “auto” selected as std
I/O channel (see Intermec Fingerprint manuals). When the
countdown is completed, you will see these lines in the display:
If you want to select another application, just cycle the power and
enter Intermec Shell before the countdown is completed.
Note: Intermec Shell is factory-installed in the printers
permanent memory (device “/rom”). If you insert a memory card
with another startup file before you switch on the printer, or if
there is a startup file stored in the printer’s permanent memory
(device “/c”), this startup file will be used instead of Intermec
Shell (see “Startup Files” on page 18).
ENTER=SHELL
5 sec. v.8.1
FINGERPRINT
8.20

Table of Contents

Other manuals for Intermec EasyCoder PX4i

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intermec EasyCoder PX4i and is the answer not in the manual?

Intermec EasyCoder PX4i Specifications

General IconGeneral
Print technologyDirect thermal
Maximum resolution300 x 300 DPI
DisplayLCD
Product colorSilver
Keyboard layoutNumeric
Standard interfacesRS-232, USB 2.0
Internal memory16 MB
Media thickness2.4/10 mm
Maximum label width120 mm
Maximum label length2.7 m
Maximum roll diameter213 mm
Supported network protocolsTCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements90 - 265 VAC, 45 - 65Hz
Power consumption (standby)20 W
Power consumption (printing)125 W
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)40 - 104 °F
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Depth482 mm
Width238 mm
Height275 mm
Weight12850 g

Related product manuals