Chapter 9 — Options
EasyCoder PX4i Bar Code Label Printer User’s Guide (Fingerprint Version) 105
3-inch Adapter
The 3 in/76 mm adapter is included in the package and makes it
possible to use media rolls with 3 in/76 mm inner diameter
cardboard cores.
The adapter is pressed onto the media supply hub and held in
place by a screw. When fitting the adapters, make sure that the
screw hits a rounded plastic surface, not a metal leaf spring.
Illustrations of how to load the media using the adapter can be
found in “Loading Media” on page 23.
Label Taken Sensor
The Label Taken Sensor (LTS) is a photoelectric sensor fitted to
the center section inside the front door. It allows the printer’s
firmware to detect if the latest printed label, ticket, tag etc. has
been removed before printing another copy.
The label taken sensor is usually factory-fitted, but is also
available as a kit for installation by an authorized service
technician. It cannot be fitted in combination with a paper
cutter.
The LTS can be enabled or disabled by means of the instructions
LTS& ON and LTS& OFF respectively in Intermec Fingerprint
and the Intermec Direct Protocol.
Real Time Clock
This factory or field-installed circuit (RTC) relieves the operator
or the host from having to set the clock/calendar using the
Intermec Fingerprint instructions DATE$ and TIME$ after each
power up. The RTC has its own backup battery backup that will
last 10 years or more.
CompactFlash Protection Plate
The protection plate encloses an inserted CompactFlash card and
makes it more difficult to steal, see illustration in “Memory
Card” on page 18. Operator-installed.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
