Intermec EasyCoder PX4i User Manual

Chapter 1 — Introduction
EasyCoder PX4i Bar Code Label Printer User’s Guide (Fingerprint Version) 3
The EasyCoder PX4i supports 15 scalable Unicode TrueType and
TrueDoc fonts as standard. Additional fonts can be downloaded
into the printer’s Flash memory, or be plugged in using a
CompactFlash card. The Unicode standard allows the use of
special characters for various languages including non-Latin
fonts, such as Arabic, Cyrillic, Chinese, Japanese, Korean,
Hebrew, and similar.
A version of EasyCoder PX4i, that supports the Intermec
Programming Language (IPL) v2.30, is described in a special
User’s Guide.
Safety Summary
Intermec assumes no responsibility regarding the CE Directive if
the printer is handled, modified, or installed in any way other
than that described in Intermec’s manuals.
• Read this manual carefully before connecting the printer.
• Moving parts are exposed when the side doors are open, so
ensure that the doors are closed before you operate the printer.
• Do not remove the left-hand cover. Dangerous voltage!
• Do not remove the bottom plate. Dangerous voltage!
• Do not put your fingers inside the print mechanism when the
power is on.
• Place the printer on an even surface which can support its
weight of approximately 13 kg (28.5 lb) plus supplies.
• Do not spray the printer with water. If you are using a hose to
clean the premises in an industrial environment, remove the
printer or protect it carefully from spray and moisture.
• Carefully read the warning text on the envelope before using a
cleaning card.
Product Identification
The machine label is attached to the printer’s rear plate and
contains information on type, model, and serial number as well
as AC voltage. It also contains regulatory agency markings
indicating compliance with specific agency regulations, if any.

Intermec EasyCoder PX4i Specifications

General

Print technology	Direct thermal
Maximum resolution	300 x 300 DPI
Display	LCD
Product color	Silver
Keyboard layout	Numeric
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.4/10 mm
Maximum label width	120 mm
Maximum label length	2.7 m
Maximum roll diameter	213 mm
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	20 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	482 mm
Width	238 mm
Height	275 mm
Weight	12850 g