Appendix B — Media Specifications
EasyCoder PX4i Bar Code Label Printer User’s Guide (Fingerprint Version) 147
Self-Adhesive Labels
(a) External Media Width (including liner)
Minimum: 25 mm (1.00 in)
Maximum: 120 mm (4.72 in)
(b) Liner Width
The liner must not extend more than a total of 1.6 mm (0.06 in)
past the edge of the face material and should protrude equally on
both sides. Recommended minimum transparency: 40% (DIN
53147).
(c) Media Width (excluding liner)
Minimum: 23.8 mm (0.94 in
Maximum: 118.4 mm (4.66 in)
(d) Label Length
Minimum (without LTS): 8 mm (0.32 in)
Minimum (with LTS): 12 mm (0.47 in) For more information,
see “Label Taken Sensor” on page 105.
Maximum: 8 dots/mm (203.2 dpi): 6,143 mm (241 in)
11.81 dots/mm (300 dpi): 4,162 mm (163 in), provided that
there is a sufficient amount of free SDRAM memory
(e) Label Gap
Recommended: 3.0 mm (0.12 in)
Minimum: 1.27 mm (0.05 in)
Maximum: 25.0 mm (0.98 in)
The Label Stop Sensor must be able to detect the extreme front
edges of the labels. For more information, see “Label Stop
Sensor” on page 132.
Opacity
The difference between in opacity between label plus liner and
liner only should be ≥ 19% units. Maximum liner opacity is
72%.
Media Type Setup: Label (with gaps)
To Next Page
Loading...
