Intermec EasyCoder PX4i - Factory Default Reset

Chapter 6 — Setting Up the Printer
60 EasyCoder PX4i Bar Code Label Printer User’s Guide (Fingerprint Version)
Description
The setup controls the printer in regard of serial communication,
test and service operations, and specifies which types of media
and ribbon are loaded in the printer.
Check the list below to see if the printer’s default setup matches
your requirements. If not, you will have to change the setup. To
enter the Setup Mode, press Setup on the printer’s
built-in keyboard and follow the instructions in “Setup Mode”
on page 77.
Setup Mode
•Press Setup on the printer’s built-in keyboard to enter the
Setup Mode.
• Select the Setup option in Intermec Shell to enter the Setup
Mode.
• Execute the Intermec Fingerprint SETUP instruction to enter
the Setup Mode.
• Access the Setup Mode via the printer’s home (requires an
optional EasyLAN interface board).
See “Setup Mode” on page 77 and the EasyLAN documentation.
Intermec Fingerprint
• Use setup strings to change individual setup parameters
remotely from the host.
• Use setup files to create sets of setup parameters remotely
from the host.
See the Intermec Fingerprint v8.3x manuals.
Intermec Direct Protocol
• Use setup strings to change individual setup parameters
remotely from the host.
See the Intermec Direct Protocol v8.3x manuals.