EasyManuals Logo

Intermec EasyCoder PX4i User Manual

Intermec EasyCoder PX4i
186 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
Chapter 6 — Setting Up the Printer
EasyCoder PX4i Bar Code Label Printer User’s Guide (Fingerprint Version) 73
Testfeed
The sensitivity of the label stop sensor (LSS) may need to be
adjusted when switching from one type of media to another. This
is especially the case when using adhesive labels since the
transparency of the liner (backing paper) may vary. When the
Testfeed menu is displayed, press Enter. A number of blank
copies will be fed out until the firmware has decided the proper
setting for the LSS. At the same time, the front edges of the
labels, tickets, etc. are detected so the feed control can position
the media according to the Feed Adjust parameter (same as the
Intermec Fingerprint statement TESTFEED). Four values used
for troubleshooting the LSS are displayed (read-only
information).
Print Defines
Head Resistance
The printhead resistance is measured automatically at startup
(read-only information).
Testprint
The test labels “Diamonds”, “Chess”, “Bar Codes #1”, and “Bar
Codes” are used to check the printout quality and facilitate
adjustment of the printhead pressure, see “Printhead Pressure
on page 131. The test labels “Setup Info” and “Hardware info
list the printer’s current setup and the installed electronic devices.
Test label “Network Info” is only printed if the printer has an
optional EasyLAN interface board. If the information does not
fit on one label, two or more labels will be printed. If the printer
refuses to print a test label, press F5/i to find out what is wrong,
for example “printhead lifted” or “out-of paper”.

Table of Contents

Other manuals for Intermec EasyCoder PX4i

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intermec EasyCoder PX4i and is the answer not in the manual?

Intermec EasyCoder PX4i Specifications

General IconGeneral
Print technologyDirect thermal
Maximum resolution300 x 300 DPI
DisplayLCD
Product colorSilver
Keyboard layoutNumeric
Standard interfacesRS-232, USB 2.0
Internal memory16 MB
Media thickness2.4/10 mm
Maximum label width120 mm
Maximum label length2.7 m
Maximum roll diameter213 mm
Supported network protocolsTCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements90 - 265 VAC, 45 - 65Hz
Power consumption (standby)20 W
Power consumption (printing)125 W
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)40 - 104 °F
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Depth482 mm
Width238 mm
Height275 mm
Weight12850 g

Related product manuals